Paradox Hellas S.A DGP2-648BL, DGP2-641BL Bypass Programming, One-Touch Buttons, Keyswitch Arming

LCD ICON LED

LCD ICON LED

4.6Bypass Programming

You can bypass certain zones when you arm the protected area(s). When a zone is bypassed, it will be ignored the next time your system is armed. Once your area is disarmed, the system will unbypass the zone.

To Bypass a zone:

1.Enter your [ACCESS CODE].

2.Press the [BYP] button or the [] key.

3.Enter the zone number (i.e. 01, 02,...96), or use the [S] and [T] buttons and press [BYP] or [] once the zone you want to bypass appears on the screen. If bypassed, the icon or the byp light does not appear on the screen and the keypad emits a rejection beep, you may not have access to bypass that zone.

4.Repeat step 3 until all zones you want to bypass have been selected.

5.Press the [ENTER] button to save and exit.

In order to bypass a zone, the following conditions must be met:

•The zone must have the Bypass option programmed by your installer.

•The Bypass option must be enabled in your User Options.

•Your user access code must have access to the zone’s Area Assignment.

•The zone’s area must be disarmed before the zone can be bypassed.

Fire Zones cannot be bypassed.

4.6.1Bypass Recall

Bypass Recall reinstates the zones that were bypassed the last time your system was armed.

To activate Bypass Recall:

1.Enter your [ACCESS CODE].

2.Press the [BYP] button or the [] key.

3.Press the [MEM] button or the [] key.

Zones bypassed the last time your system was armed are bypassed.

4.Press the [ENTER] button to save and exit.

4.7One-Touch Buttons

If enabled by your installer, you can access the following features without using your user access code by pressing and holding the desired One-Touch button.

			Table 3: One Touch Button
Button	Icon		Feature
[ARM]	[	]	Regular arm
[STAY]	[	]	Stay arm
[FORCE]	[	]	Force arm
[BYP]	[	]	Bypass Programming
[DISARM]	[	]	Disarm a Stay/Instant armed area
[5]			Instant arm
[6]			Change display settings
[7]			View Event Record display (DGP2-641BL/RB only)

LCD ICON LED	4.8 Keyswitch Arming
	A key can be used to arm and disarm your system using two forms of keyswitches. With a
	Maintained Keyswitch, place the key in the “ON” position to arm your system, and place
	the key in the “OFF” position to disarm your system. With a Momentary Keyswitch, place
	the key in the “ON” position briefly then place it back in the “OFF” position to arm the
	system. Repeat this process to disarm with a Momentary Keyswitch.

User’s Manual 7