Configuration Worksheet for Basic (DBM-V, DBM-S, or DBM-D)Date:________________________________________________ Location:_____________________________________________ Local Phone No.: ( j)______________________________
Device:______________________________________________ Local Address:_________________________________________ j DBM Installed
Serial No.:____________________________________________ Tributary Network Address:_______________________________ j SNA Diagnostic Interface (LPDA-2) Installed
Diagnostic DBM
Options Value
Diag Type NonD, [Disr], Mixed, None
2nd Ch(bps) 100, [400], 800, 1200, 1600
RemoteDiag V.54, [Enhan], 2500
Diagnostic General
Options Value
Position [Cntrl], Trib, G2Trb
LinkConfig [Pt-Pt], M-Pt
Resp Period [1], 2, 10
Trib TimOut
(Chang)
sec. to min
[10 sec]
Diag Conn [CC], DC
Link Delay [0s], 1s, 2s, 5s, 10s, 20s, 50s
Network Delay [0s], 1s, 2s, 5s, 10s, 20s, 50s
Packet Delay [0s], 1s, 2s, 5s
M-Pt SymPrt Enab, [Disab]
Fast Sel [Enab], Disab
ChMd Options Value
Mode DPII, ADp, DMC
Hardware Straps Value
DDD Interface{Permissive, Programmable
Frame Ground/
Signal Ground Connected, Disconected
Test Mode Indication Enable, Disable
Note: Values shown in [Bold] are factory-set defaults.
{Not available if a DBM-S or DBM-D
{{ Not available if a Primary Core is No
* DBM-S or DBM-D only
** DBM-D only
General Options Value
DTE Port [EIA232], V.35
RTS Cntrl [FrcOn], DTE
CTS Cntrl [Std], =RTS
AnitStream
(Chang)
[Disab], 1–100 sec (async terminal = 1–100)
LSD Lead [Std], Delay, FrcOn
CTS Lead [Std], Delay, FrcOn
DSR FrcOn Enab, [Disab]
SystemStat [Enab], Disab
DSR on Tst [Enab], Disab
Circ Assur Enab, [Disab]
Tst Pattern AT&T, [Std]
RespondRDL Enab, [Disab]
LL by DTE Enab, [Disab]
RL by DTE Enab, [Disab]
Bilat Lpbk Enab, [Disab]
Ext Leads ExtLd, [Rate], RPower
CCN by EL Enab, [Disab]
DTR Alarm Enab, [Disab]
SW Vers 3.22, 4.41, [Normal]
Async→Sync Enab, [Disab]
AsyncBit/Char 6, 7, [8], 9, 10
Stop Bits [1], 2
Overspeed 1.0, [2.3]
Backup Options Value
Auto Bckup Enab, [Disab]
Backup Dir
(Chang)
1–10 [1]
BckupOnCMI Enab, [Disab]
AutoRestor Enab, [Disab]
NtwkTimOut
(Chang)
min and sec [20 sec]
RestorTimOut
(Chang)
min [5 min]
TriesTimeOut
(Chang)
min [15 min]
MultiCall Enab, [Disab]
DBM Options Value
Rate(Kbps) 14.4, 12.0, [9.6], 4.8, 2.4
or
[56]
PrtSp(Kbps) 14.4, 12.0, [9.6], 9.2, 8.4, 7.2, 4.8,
4.4, 4.0, 2.4, 2.0, 1.2, Disab
or
[56], 48, 38.4, 32, 28.8, 19.2, 18.8,
18.0, 16.8, 14.4, 12.0, 9.6, 9.2, 8.4,
7.2, 4.8, 4.4, 4.0, 2.4, 2.0, 1.2, Disab
TxClkSource{[Int], RXC, DSU
CarrLossDisc{[Yes], No
Auto Retrain{[Yes], No
Single Rate{[Yes], No
AutoAnswer [Enab], Disab
TxElasStor Enab, [Disab]
RxElasStor Enab, [Disab]
Call Setup [None], Pswrd, Cllbk, Alarm
RxPwd
(Chang)
TxPwd
(Chang)
V.13 Signl Enab, [Disab]
Dial Test Enab, [Disab]
Primary Core [Yes], No
DtrCallCon Orig{{, Ansr, [Disab]
EchoCancel*Enab, [Disab]
Remote DBM** 2-wire, [4-wire]
Backup Directory Dial String
1
3
4
5
6
7
8
9
10