COMSPHERE 392xPlus Modems
3-44 November 1996 3920-A2-GN31-30
From the Choose DLL T
ype screen, press the F1 key to select SC_Clone to request the transfer of
an exact copy of the tributary modem’s firmware to the VF connected control modem.
Proceed to the section titled Implementing a Clone Remote Operation, which follows the
descriptions of multipoint cloning operations.
Cloning DC Broadcast Remote
Before using Clone Remote in DC Broadcast configurations, make sure the tributary modem’s
active poll list contains all the network management addresses for the control modems that receive
the download (refer to the Poll List Branch section in this chapter), and ensure that the control
modems are responding properly to polls (refer to the
Sub-Network Health and Status
branch
section in this chapter).
F1
Choose DLL Type >
DC_Broadcast
F2 F3
From the Choose DLL T
ype screen, press the
key until DC_Broadcast appears. Press F1 or F2
to transfer an exact copy of the tributary modem’s firmware to the DC-connected control
modem(s) using the Active Poll list.
Proceed to the section titled Implementing a Clone Remote Operation, which follows the
descriptions of multipoint cloning operations.
Viewing DC Broadcast Clone Results
F1
Choose DLL Type >
DC_CloneResults
F2 F3
From the Choose DLL T
ype screen, press the
key until DC_CloneResults appears to view the
results of the last DC_Broadcast clone operation. If the message
Trib List Empty
appears, this
indicates that a multiple download was never initiated.
F1
DC Clone Results
Nxt xxx Pas s
F2 F3
The address field (xxx) displays the network management address of one of the remote modems.
Pressing the F1 key allows you to select various remote modems to determine the download result
for those modems (Pass or Fail).