Paradyne 727 4.Test Status Messages, Meaning, Refer to Network Interface Options, Table A-2

Monitoring the DSU

Test Status Messages

The Test Status Messages in the following table appear in the rightmost column of the System and Test Status screen.

Table 4-4. Test Status Messages

Test Status Message	Meaning
No Test Active	Status message, indicating no local, remote, or network test in
	progress.
CSU Loopback Active	A CSU Loopback toward the network is currently active.
Network-init. CSU LB	A CSU Loopback initiated by the network is currently active.
Active
DSU Loopback Active	A DSU Loopback toward the network is currently active.
Network-init. DSU LB	A DSU Loopback initiated by the network is currently active.
Active	H If the network service is 56 kbps, the network loopback is
	non-latching. A non-latching loopback ends when the
	network activation codes stop.
	H If the network service is 64 kbps CC, the network loopback
	is latching. This condition can only occur when the Network
	Interface option Network-initiated DSU Loopback (64K CC)
	is enabled. Refer to Network Interface Options, Table A-2.
V.54-initiated DSU LB	A DSU loopback is active that was initiated by the detection of
Active	a V.54 sequence originated by the remote unit. This condition
	can only occur when V.54 Initiated DSU Loopback is enabled.
	Refer to Network Interface Options, Table A-2.
Local Loopback Active	A local loopback toward the DTE is currently active.
Sending 511 on Port	A 511 test pattern is being sent over the DTE port.
Monitoring 511 on Port	DSU is monitoring a 511 test pattern over the DTE port.
Sending 511 on	A 511 test pattern is being sent over the network interface.
Network
Monitoring 511 on	DSU is monitoring a 511 test pattern on the network interface.
Network
Lamp Test Active	The Lamp Test is active, causing the LEDs on the front panel to
	light.

7510-A2-GB20-00 March 1997 4-5