Paradyne 7511 Installing the DSU Card

7511-A2-GN10-10 January 1999

Installing the DSU Card

Procedure

To install the Model 7511 Dual DSU:

1. Using a Phillips screwdriver, loosen the screw holding the circuit pack lock.

Rotate the lock to the open position and open the latch.

Circuit

Card

Guides

Circuit

Pack

Lock

Latch

Open

(Unlocked)

Closed

(Locked)

495-14813

2. At the front of the carrier, hold the circuit card vertically with the latch on its

faceplate in the open position. Then insert the circuit card into the top and

bottom circuit card guides.

Contents

Main Model 7511 Dual DSU Startup Instructions Document Number 7511-A2-GN10-10 Technical Manuals Product Documentation on the World Wide Web Subrate Digital Access Devices. Model 7511 Dual DSU Users Guide Preparation Package Checklist Cables You May Need to Order Important Safety Instructions Cables and Pin Assignments, Installing the Dual DSU !HANDLING PRECAUTIONS FOR Figure 1. Model 7511 Switch Locations Table 1. Configuration Options (1 of 5) Table 1. Configuration Options (2 of 5) Table 1. Configuration Options (3 of 5) Table 1. Configuration Options (4 of 5) Table 1. Configuration Options (5 of 5) Installing the Rear Connector Plate Installing the DSU Card 10 Installing the Network and DTE Cables Troubleshooting 13 Symptom RecommendationsPossible Cause Testing Technical Specifications !Important Safety Instructions Notices !WARNING: Government Requirements Notice to Users of the Telephone Network in the United States Technical Specifications Warranty, Sales, and Service Information Notice to Users of the Canadian Telephone Network