Paradyne 8620 PdnMgmtIpAddress RW, PdnMgmtIpNetMask RW, PdnMgmtIpEthGateway RW, PdnMgmtBootVpi RW

7.6.1.2pdnMgmtIpAddress (RW).

The IP address assigned to this port. If the pdnMgmtIpConfigMode is set to modes other than ’manual’, then the MAX-ACCESS for this object is read-only and the value of the object represents the actual IP address assigned to the port by the DHCP client (or 0.0.0.0, if none assigned). Changes to this object could disrupt data flow through the port.

7.6.1.3pdnMgmtIpNetMask (RW).

The IP subnet mask assigned to this port.

The MAX-ACCESS for this object behaves the same as the pdnMgmtIpAddress explained above. Changes to this object could disrupt data flow through the port.

7.6.1.4pdnMgmtIpEthGateway (RW).

The IP Gateway for an ethernet based IP port.

This object is supported only on IP ports that are configured to run over ethernet type of media. This object would be set to 0.0.0.0 for other types of interfaces and is not valid.

7.6.1.5pdnMgmtIpPhysAddress (RW).

The physical address associated with the media.

For IP Ports with Ethernet type of media, the MAX-ACCESS for this object is restricted to read-only. In such cases, this object would reflect the MAC address of the underlying ethernet data link. For IP Ports that run over ATM PVCs, this object is writable.

7.6.1.6pdnMgmtIpConfigMode (RW).

The IP configuration mode for the port. The possible values are: manual(1), dhcp(2).

In “manual” mode, it is up to the user to provide the IP address and IP subnet mask of the port.

In “dhcp” mode, the respective protocols are resposible to obtain and populate the IP address and IP subnet mask for the port. The default value for all the interfaces is dhcp(2).

Whenever the config mode is changed from “manual” mode, the IP address and the IP subnet mask for the port would automatically be reset to 0.0.0.0. External Manager stations SHOULD NOT attempt to write the IP address or the IP subnet mask of the port when this object is not in “manual” mode.

7.6.1.7pdnMgmtBootIfIndex (RW)

The interface index of the ATM interface to be used by the DHCP client, if the pdnMgmtIpConfigMode is set to “dhcp” respectively. For the Ethernet’s IP port, this object is 0.

7.6.1.8pdnMgmtBootVpi (RW)

The VPI of the ATM PVC to be used by the DHCP client, if the pdnMgmtIpConfigMode is set to “dhcp” respectively.

7.6.1.9pdnMgmtBootVci (RW)

The VCI of the ATM PVC to be used by the DHCP client, if the pdnMgmtIpConfigMode is set to “dhcp” respectively.

7.6.1.10pdnMgmtIpAdminStatus (RW)

The status of the IP Port (interface). Possible values are up(1), down(2).

8000-A2-GB30-10 November 2003 75