2.0INSTALLATION
CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.
2.1Unpack and Inspect the SAM2000G
If there is visible damage, do not attempt to connect the device; contact Customer Support at
2.2Install the SAM2000G in an IP DSLAM Chassis
NOTE There must be a Multiplexer Uplink Module (MUM) installed in your IP DSLAM chassis in order for interface modules to operate.
Net to Net Technologies' IP DSLAM interface modules are hot swappable; installing or removing an interface module while the chassis is powered up does not affect the operational status of other interface modules within the chassis. The IPD12000 is a fourteen slot chassis; slots
zAlign the SAM2000G with the module guides in the slot chosen for installation (slot
zSlide the SAM2000G firmly into the chassis. DO NOT USE EXCESS FORCE.
zSecure the SAM2000G by tightening the fastening screws on the module faceplate.
zVerify that the PWR (Power) LED on the SAM2000G faceplate is illuminated.
2.3Connect the SHDSL Line(s)
Plug the SHDSL cable into the RJ21 port, of the chosen slot, on the back of your IP DSLAM. Verify your connections; the SHDSL LK LED for each connected port will illuminate solid or pulsing green.