
Interface Module User Guide
TAM1500-12
CAUTION Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when handling this equipment.
INSTALLATION
1.Unpack and inspect the TAM1500-12.
If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-
2.Install the TAM1500-12 in an IP DSLAM chassis.
NOTE There must be a Multiplexer Uplink Module installed in the IP DSLAM chassis in order for Access Modules to operate.
All Access Multiplexer Modules for Net to Net Technologies' IP DSLAMs are hot swappable; installing or removing an Access Module while the chassis is powered up does not affect the operational status of other Access Modules within the chassis. The IPD12000 is a fourteen slot chassis; slots
a.Align the
b.Slide the
c.Secure the
d.Verify that the PWR (Power) LED on the