Parasound A 23 manual Automatic On-Off, Connecting An External Dc Source For, What You’ll Need

CONNECTING AN EXTERNAL DC SOURCE FOR	8
AUTOMATIC ON-OFF

If you want to automatically turn on and off the A 23 with an external DC voltage, choose the DC Triggering option by moving the Auto Turn On switch on the rear panel to its lower 12V position.

What You’ll Need:

• A cable with a 2.5 mm sub-mini plug on each end (provided)

• A “control” component with +9Vdc to +12Vdc trigger voltage

2.5 mm sub-mini plug

Before Connecting

Remove Power to all the components in your audio system.

Make sure the AutoTurn On switch on the a 23 rear panel is in it 12V (down) position.

To Connect

1Plug one end of the trigger wire into the 12V Input jack on the A 23.

2Plug the other end of this wire into the external DC source

1

C A U T I O N

2

Output

CONTROL COMPONENT

YOU SHOULD KNOW

If the device you want to use to control your A 23 doesn’t have a 2.5 mm trigger output connector, you can cut one plug off the cable and terminate the end as required. The lead with the red stripe is positive and the lead without the stripe is negative.