5 | CONNECTING SPEAKERS TO THE A 23 |
|
|
Speaker Terminals
The
What You’ll Need:
•Two lengths of speaker wire AWG 16 or thicker with banana plugs, spade lugs, or bare wire
•Loudspeakers or a speaker selector box
Common Speaker Connectors
The GND notch | Red ususally |
signifies ground | designates right |
or speaker left |
|
Dual | Single | Spade Lug | Stripped |
Banana Plug | Banana Plug |
| AWG wire |
Before Connecting
Remove power to all the components in your audio system.
To Connect
1Insert one wire with the ridge or other marking into the red Right + (positive) speaker
terminal on the A 23. Insert the wire without the ridge or other marking into the black Right - (negative) speaker terminal on the A 23.
2Insert the other end of the wire with the ridge or other marking into the red right +
(positive) terminal on the speaker. Insert the wire without the ridge or other marking into the black right - (negative) terminal on the speaker.
3&4 Repeat steps 1 and 2 for the left channel
C A U T I O N | 1 | 3 |
|
|
| ||
| 2 | 4 | Speakers |
|
|
|
YOU SHOULD KNOW
Correct Speaker Polarity is Important
Polarity refers to + and – connections. Speaker wires are coded with printing or a ridge on the insulation on one of the leads so you know which lead was connected to the + and – terminals at the other end. This coding will help you keep the + and - polarity consistent for both channels.
Speaker Wire Length and Gauge (thickness)
When selecting speaker wire, follow these guidelines:
•Keep the length of your speaker wire as short as possible
•Use the thickest wire practical. For lengths greater than 50 feet, use speaker wire with an AWG (gauge) of 14 or lower. The smaller the AWG, the thicker the wire.
•Do not use speaker wire that is thinner than 16 AWG.
•Keep wire lengths for both channels as close to equal as possible.