To Automatically Set the Analog Input Level:
1.Play material through the input source. Select source material with loud transient peaks.
2.Press and hold the Setup/Trim button on the remote control until SOURCE SETUP appears on the front panel or
3.Press the Tune < or > buttons until ANALOG INPUT appears in the displays.
4.Press the A.Cal button on the remote until graphic level meters appear in the displays. You do not need the calibration mic for this procedure.
5.The
6.Press the Tune > button to advance to the next SOURCE SETUP procedure, or press and hold the Setup/Trim button for three seconds to return to normal operation.
Setup Menu Level Two - Bass Management
Bass management is designed to assure overall balanced bass response by accommodating many different types of speaker systems that may or may not be able to reproduce frequencies below 80 Hz. The Bass Management setup menu lets you configure all of your speakers to accept low frequencies below 80 Hz, or to filter out these frequencies and route them to your front speakers, or send them only to your subwoofer channels. THX certified speaker systems should always be set to "SMALL/THX for the left, right, center, and surround outputs. Additionally, there should always be a subwoofer in a THX speaker system
To Setup Bass Management for Your Front Left and Right Speakers:
1.Press and hold the Setup/Trim button on the remote control until SOURCE SETUP appears on the front panel or
2.Press Setup/Trim again until BASS MGMT SETUP appears in the displays. If you are continuing from the previous setup menu, you only need to press Setup/Trim again. MAIN: and LARGE appear in the displays.
3.Refer to the owner’s manual of your front left and right speakers to determine whether they are designed to reproduce frequencies below 80 Hz.
4.If the Main (Left and Right) speakers are designed to handle frequencies below 80 Hz, press the Volume g or h buttons to select LARGE . The front left and right speakers will operate full range (20 Hz to 20 kHz).
5.If they were not designed for low frequencies, select SMALL/THX. The front left and right speakers will have low frequencies rolled off 12 dB per octave starting at 80 Hz.
6.Press the Tune e button to advance to center channel bass management options, or press and hold the Setup/Trim button for three seconds to exit BASS MGMT SETUP and return to normal operation.
To Setup Bass Management for Your Center Speaker:
1.If you are not already in the Bass Management setup menu, follow steps 1 and 2 from above and use the Tune f or e buttons until CENTER and LARGE appear in the displays.
2.Press the Volume g or h buttons to select either SMALL/THX, LARGE, or NONE.
3.Refer to the owner’s manual of your center speaker to determine whether it is designed to reproduce frequencies below 80 Hz.
4.If the center speaker is designed to safely reproduce frequencies below 80 Hz, select LARGE. The center speaker will operate full range (20 Hz to 20 kHz).
5.If it is not designed for low frequencies, select SMALL/THX. The center speaker will have low frequencies rolled off 12 dB per octave starting at 80 Hz. This low frequency information is then
6.If you do not have a center channel speaker, select NONE and the
7.Press the Tune e button to advance to surround channel bass management options, or press and hold the Setup/Trim button for three seconds to exit BASS MGMT SETUP and return to normal operation.
41
