Parasound AVC-2500 Event Label, Event Executed to Activate Trigger, Triggering Examples

The following describes the list of event labels in the DC TRIGGER setup menu and which event activates the Main (1) or Zone (2) Triggers.

Event Label	Event Executed to Activate Trigger
Power	DC Trigger is activated by turning on the system from that zone.
Manual	DC Trigger is manually activated by pressing the Shift + Volume
	g or h buttons.
Dimmer	DC Trigger is on as long as the front panel dimmer is off.
Status	DC Trigger is on when the status display is activated or setup menus
	are on.
Source:	DC Trigger is activated when TRIGGER SOURCE = YES has been set in
	the SOURCE SETUP menu, (see above) and the source has been selected.
Component video:	DC Trigger activates when a Source with an assigned Component
	Video is selected.
Digital input:	DC Trigger activates when there is no signal present at any of the
	Digital inputs.
	Triggering Examples
Power:	Turning on a power amplifier when the AVC-2500 is powered on.
Manual:	Manually activating a component or accessory.
Dimmer:	Dimming room lights at the same time the front panel dimmer is
	activated.
Status:	Turning on an “operator light” near the equipment when the Status
	display is activated.
Source:	Controlling various Source-dependent devices, lights, curtains,
	screens, etc.
Component video:	Controlling various Component Video output-dependent devices,
	screens, projectors, etc.
Digital input:	Controlling various digital components, for example to turn lights on
	when a DVD stops playing.

Setup Menu Level Seven – System Setup Procedures

These procedures are for setting miscellaneous system settings including setting the sleep timer’s attenuation rate, and restoring all factory default settings.

1.Press and hold the Setup/Trim button on the remote control until SOURCE SETUP appears on the front panel or on-screen display.

2.Press Setup/Trim until SYSTEM SETUP and SLEEP RAMPING: FAST appear in the displays.

3.Press the Volume g or h buttons to select SLOW if you want the audio to fade slowly during the last three minutes of the sleep timer.

4.Press the Tune f or e buttons until and TUNER REGION: US/CANADA or EUROPE appears in the displays.

5.Press the Volume g or h buttons to select US/CANADA or EUROPE.

6.Press the Tune f or e buttons until and FACTORY RESET appears in the displays.

7.Press the Mem/Enter button to restore factory default settings.

Warning! Pressing the Mem/Enter button immediately erases all of your previously programmed settings.

8.The AVC-2500 turns off after resetting factory defaults.

9.Press the Setup/Trim button to return to normal operation.

46