Setup
XA200 Owner’s Manual
dard 15 amp IEC receptacle at the rear of the amplifier chassis. Two XA200’s may be run on a single
As a safety issue we suggest that the power cord should be the last cable installed on your
The amplifier’s voltage and current rating are indicated on the rear panel. It will be either 240 volts, 220 volts, 120 volts or 100 volts, all with a restorable type circuit breaker of the appropriate ampacity. The inclusion of this
Looking at the rear panel you will see the AC power cord receptacle, a power switch / breaker, two pairs of output connectors which allow for speaker
Make sure that the rear panel power switch/breaker is off (down). Plug the AC cord into the back of the amplifier, and then into the wall. Then turn the power switch/breaker on (up). The lights in your house will blink when the power supply charges the capacitors. (Note: The power switch/breaker is never to be used as a “safety device” or “emer- gency disconnect” for this product. This device provides current limit- ing which will protect the amplifier, it will not provide personal shock protection in the event of a reversed hot / neutral, lack of grounding or other improper wiring in the supplied mains voltage.)
On the front panel, the “Standby” LED indicator should be glowing blue, indicating that AC power is available and the capacitor banks are
4