SmartNode 4400 Quick Start Guide
Introduction
This Quick Start Guide leads you through the basic steps to set up a new SmartNode and to download a con- figuration. Please note that this guide does not replace the detailed Software Configuration Guide and the Get- ting Started Guide on the
SmartNodes can be used for a wide variety of IP and voice over IP applications. To support and ease the config- uration of the SmartNodes, configuration templates for the most important applications are available online at http://www.patton.com/voip/appnotes.shtml.
Setting up a new SmartNode consists of the following steps:
1.Attach the power cable retainer clip to the unit
2.Connect a PC to the SmartNode, log in and configure your LAN IP address (see page 5 for details)
3.Connect the SmartNode to the LAN (see page 7)
4.Download a configuration example, adapt it to your network, and load it onto the SmartNode (see page 8)
Attaching the cable retainer clip
To secure the power cord, it is necessary to attach the metal retainer clip (if applicable to your model). Squeeze the clip and insert into the holes in the screws on either side of the power connector on your unit. The clip will pop into place.
Power cable retainer clip
Figure 1. Attaching the cable retainer clip
Note Refer to the Getting Started Guide on the
Introduction | 4 |
