Patton electronic 1058 user manual Standalone Unit Installation

3.0 INSTALLATION

Because the VLINK modem requires no configuration, it can be installed quickly. If you are installing a standalone unit, refer to section 3.1 “Standal- one unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.

Note If asymmetric transmission or line rates other than 12.5 Mbps are required (Model 1068 only), refer to section 4.0, “Configura- tion (Model 1068 Only)” on page 15.

3.1 STANDALONE UNIT INSTALLATION

Do the following:

1.Connect the line interface between the units (refer to section 3.3, “Connecting the Twisted-Pair Line Interface” on page 11)

Note See Figure 2 for the standalone unit’s rear panel arrangements.

2.Connect the Ethernet interface (refer to section 3.4, “Connecting the 10/100Base-T Ethernet Interface” on page 12).

3.Connect the power plug (refer to section 3.6, “Connecting Power” on page 14).

Figure 2. VLINK modem standalone rear panel

9