Patton electronic 1058 user manual Connecting Power, Vlink RJ-45 POTS/ISDN interface

work. The RJ-45 connector in the VLINK modem’s POTS/ISDN interface is wired as shown in Figure 9.

	1 (no connection)
1	2 (no connection)

23 (no connection)

4	4	(2-wire RING)
5	5	(2-wire TIP)
6	6	(no connection)
7
	7 (no connection)
8

8 (no connection)

Figure 9. VLINK (RJ-45) POTS/ISDN interface

3.6 CONNECTING POWER

An external AC or DC power supply is available separately. This connec- tion is made via the barrel jack on the rear panel of the VLINK standalone modem. No configuration is necessary for the power supply (See Appen- dix B for domestic and international power supply and cord options).

DC power (supplied via the power supply jack to the VLINK modem) must meet the following requirements; DC power supplied must be regu- lated +5VDC ±5%, 1.0A minimum. Center pin is +5V. The barrel type plug has a 2.5/5.5/10mm I.D./O.D./Shaft Length dimensions.

The VLINK modem does not have a power switch, so it powers up as

soon as it is plugged in.

There are no user-serviceable parts in the VLINK modem.Fuse replacement should only be performed by qualified service personnel. Contact Patton Elec- tronics Technical support at (301) 975-1007 for more information.

WARNING

14