Patton electronic 1090 user manual Features, Description, External DIP Switch Settings

2.0 GENERAL INFORMATION

Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Technical Support at (301) 975-1007.

2.1 FEATURES

•Synchronous data rates of 48, 56, 64, 72, 80, 112, 128, 144 and 160 kbps

•Frequency Shift Key (FSK) modulation

•Full or half duplex operation over two twisted pair (4-wire)

•Point-to-point distances up to 11 miles (19 AWG @ 56 kbps)

•V.54 compliant local analog (LAL), remote digital (RDL) and local digital loopback tests

•V.52 compliant Bit Error Rate (BER) test pattern generator

•Replaceable DTE-DCE QuickConnect™ interface modules

•V.52 compliant BER test pattern generator

•Internal, external or receive recovered clocking options

•Automatic equalization

•Made in the U.S.A.

2.2 DESCRIPTION

The Patton Model 1090 Synchronous Short Range Modem is designed for point-to-point, high speed communication over 4-wires (two twisted pair). Supporting switch-selectable data rates from 48 to 160 kbps, the Model 1090 is perfect for connecting two bridge/routers, or for similar campus applications at distances up to 11 miles. The Model 1090 incorporates built-in V.54 loopback tests, a V.52 BERT pattern generator and seven front panel LED indicators. Data integrity is enhanced by automatic equalization and gain control. The Model 1090 also incorporates transformer isolation and surge protection to guard data and connected equipment against the hazards of ground loops and transient surges. Clocking options include internal, external and receive recover clock.

The Model 1090 is the first Patton product to feature replaceable DCE- DTE QuickConnect™ interface modules. Several different modules are available (call Patton Sales for details). Line connection is made by RJ- 45 jack. Internal AC power supply options include 120 or 230VAC (switchable), 85-256VAC (universal) or 48VDC.

3

3.0 CONFIGURATION

The Model 1090 is equipped with one set of eight DIP switches, and one set of four DIP switches (all externally accessible). These DIP switches allow configuration of clock source, carrier control, loopback tests and data rate. This section describes switch locations and explains all possible configurations.

3.1 EXTERNAL DIP SWITCH SETTINGS

The Model 1090’s DIP switches are located on the underside of the unit (see Figure 1, below). Figure 2 (below), shows the orientation of the switch set. All possible settings for the Model 1090’s DIP switches are presented in the summary table and descriptions on the following pages. If you have additional questions regarding configuration, contact Patton Technical Support at (301) 975-1007.

REAR

S1 S2

8	7	6	5	4	3	2	1	4	3	2	1
							ON			ON

FRONT

Figure 1. Underside of Model 1090 Wish External DIP Switch Locations

ON								ON
S1											S2
1	2	3	4	5	6	7	8	1	2	3	4

Figure 2. Close Up of Configuration Switches

4