Manuals / Patton electronic / Computer Equipment / Network Card

Patton electronic Model 2172 Terminal Block twisted pair line interface, Power Ethernet

Models: 2172

1 22

Download 22 pages 12.19 Kb

Page 11

Power

USA

in	the
in
Made

Power

Ethernet

Loc

Rem

RING TIP

Figure 4. Model 2172 (Terminal Block) twisted pair line interface.

3.2 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE

The Interconnecting cables shall be acceptable for

external use and shall be rated for the proper applica-

tion with respect to voltage, current, anticipated tem-

CAUTION perature, ﬂammability, and mechanical serviceability.

The shielded RJ-45 port labeled Ethernet is the Auto-MDIX10/100Base- T interface. This port is designed to connect directly to a 10/100Base-T network. Figure 5 shows the signal/pin relationships on this interface. You may connect this port to a hub or PC using a straight through or crossover cable that is up to 328 ft long.

	1 TX+/RX+
1	2 TX-/RX-

23 RX+/TX+

	4	4	(no connection)
	4
	5	5	(no connection)
	6	6	RX-/TX-
	7	6	RX-/TX-
	7	7 (no connection)
	8	7 (no connection)

8 (no connection)

Figure 5. Model 2172 10/100Base-T RJ-45 Connector Pinout.

11

Image 11

Patton electronic Model 2172 Terminal Block twisted pair line interface, Model 2172 10/100Base-T RJ-45 Connector Pinout

Contents

An ISO-9001Certiﬁed Company USER MANUALMODEL CopperLINK High Speed Ethernet ExtendersCONTENTS CopperLINK Interface Distance Chart, Based on 24 AWG 0.5 MM10/100Base-T Interface RJ-451.2 RADIO AND TV INTERFERENCE FCC PART 1.0 WARRANTY INFORMATIONSafety Compliance 1.1 COMPLIANCE EMC ComplianceTel +1 301 Email support@patton.com 1.4 SERVICE1.3 DECLARATION OF CONFORMITY 1.5 SAFETY WHEN WORKING WITH ELECTRICITY 2.2 DESCRIPTION 2.1 FEATURES2.0 GENERAL INFORMATION tion with respect to voltage, current, anticipated tem 3.0 INSTALLATION The Interconnecting cables shall be acceptable forCAUTION perature, ﬂammability, and mechanical serviceability external use and shall be rated for the proper applica2172 RJ-45 2172 Terminal block 1 no connection Figure 4. Model 2172 Terminal Block twisted pair line interface Figure 5. Model 2172 10/100Base-T RJ-45 Connector PinoutPower Ethernet The Model 2172 does not have a power switch, so it powers up as soon as it is plugged in High Speed Ethernet ExtenderCopperLINK Figure 7. DIP switch orientationPower Figure 6. Removing protective cover4.2 CONFIGURING DIP SWITCH S2 Table 5 Ethernet conﬁgurations Table 4 Asymmetric CopperLINK Line Rates Selection ChartS2-7 S2-85.2 FRONT PANEL LED STATUS MONITORS 5.1 POWER UP5.0 OPERATION Power APPENDIX A Base Models Power SuppliesPower Cords Only required with optional UI power supply 08055DCUIC.2 COPPERLINK INTERFACE RJ-45 Power EthernetAPPENDIX C C.1 10/100BASE-T INTERFACE RJ-45DISTANCE CHART, BASED ON 24 AWG 0.5 MM Copyright 2001, 2002 Patton Electronics Company All Rights Reserved