Patton electronic 2190 SUB Parameter Definitions, FAX Commands, FAX Class 1 Commands, +Faxerr

	Dial Codes (continued)
Dial Code	Dial Functions
;	Return to command state. Added to the end of a dial string,
	this causes the modem to return to the command state after
	it processes the portion of the dial string preceding the ”;”.
	This allows the user to issue additional AT commands may
	be placed in the original command line following the ”;”
	and/or may be entered on subsequent command lines. The
	modem will enter call progress only after an additional dial
	command is issued without the ”;” terminator. Use ATH0 to
	abort the dial in progress, and go back on-hook.
^	Enable calling tone. Applicable to current dial attempt only.
( )	Ignored. May be used to format the dial string.
-	Ignored. May be used to format the dial string.
<space>	Ignored. May be used to format the dial string.
<i>	Invalid character. Will be ignored.
>	If enabled by country specific parameter, the modem will
	generate a grounding pulse on the EARTH relay output.

4.4 SUB PARAMETER DEFINITIONS

This section describes the Model 2190 sub parameters. Listed below are various modulations with the possible rates that the Model 2190 supports.

<mod>	Modulation	Possible Rates (bps)	Notes
0	V.21	300
1	V.22	1200
2	V.22bis	2400 or 1200
3	V.23	1200
9	V.32	9600 or 4800
10	V.32bis	14400, 12000, 9600, 7200, or 4800
11	V.34	33600, 31200, 28800, 26400, 24000,	Default
		21600, 19200, 16800, 14400, 12000,
		9600, 7200, 4800, or 2400
64	Bell 103	300
69	Bell 212	1200
74	V.FC	28800, 26400, 24000, 21600, 19200,
		16800, or 14400

<automode>	Option Selected	Notes
0	Automode disabled
1	Automode disabled using V.8 or	Default
	multi-mode

15

4.5 FAX COMMANDS

The following section describes the Model 2190 fax commands. The fax commands are divided into two listings; the first list shows the fax class 1 commands, and the second list shows the fax class 2 commands. The information listed below identifies the codes and its function.

4.5.1 FAX CLASS 1 COMMANDS

+FCLASS=n	Service class
+FAE=n	Data/fax auto answer
+FRH=n	Receive data with HDLC framing
+FRM=n	Receive data
+FRS=n	Receive silence
+FTH=n	Transmit data with HDLC framing
+FTM=n	Transmit data
+FTS=n	Stop transmission and wait
4.5.2 FAX CLASS 2 COMMANDS
+FCLASS=n	Service class
+FAA=n	Adaptive answer
+FAXERR	Fax error value
+FBOR	Phase C data bit order
+FBUF?	Buffer size (read only)
+FCFR	Indicate confirmation to receive
+FCLASS=	Service class
+FCON	Facsimile connection response
+FCIG	Set the polled station identification
+FCIG:	Report the polled station identification
+FCR	Capability to receive
+FCR=	Capability to receive
+FCSI:	Report the called station ID
+FDCC=	DCE capabilities parameters
+FDCS:	Report current session
+FDCS=	Current session results
	16