Fax Class 2 commands (continued)
+FDIS: | Report remote capabilities |
+FDIS= | Current sessions parameters |
+FDR | Begin or continue phase C receive data |
+FDT= | Data transmission |
+FDTC: | Report the polled station capabilities |
+FET: | Post page message response |
+FET=N | Transmit page punctuation |
+FHNG | Call termination with status |
+FK | Session termination |
+FLID= | Local ID string |
+FLPL | Document for polling |
+FMDL? | Identify model |
+FMFR? | Identify manufacturer |
+FPHCTO | Phase C time out |
+FPOLL | Indicates polling request |
+FPTS: | Page transfer status |
+FPTS= | Page transfer status |
+FREV? | Identify revision |
+FSPL | Enable polling |
+FTSI: | Report the transmit station ID |
4.6 VOICE COMMANDS
This section describes the voice commands on the Model 2190. The list below provides the voice command codes and its function.
#BDR | Select baud rate (turn off autobaud) |
#CLS | Select data, fax, or voice. |
#MDL? | Identify model |
#MFR? | Identify manufacturer |
#REV? | Identify revision level |
#SPK= | Speakerphone setting |
#TL | Audio output transmit level |
#VBQ? | Query buffer size |
| 17 |
| Voice Commands (continued) |
#VBS | Bits per sample |
#VBT | Beep tone timer |
#VCI? | Identify compression method |
#VGT | Set playback volume in the command state |
#VLS | Voice line select |
#VRA | Ringback goes away timer (originate) |
#VRN | Ringback never came timer (originate) |
#VRX | Voice receive mode |
#VSD | Enable silence deletion (no function, com- |
| mand response only). |
#VSK | Buffer skid setting |
#VSP | Silence detection period (voice receive) |
#VSR | Sampling rate selection |
#VSS | Silence detection tuner (voice receive) |
#VTD | DTMF/tone reporting |
#VTM | Enable timing mark placement |
#VTS | Generate tone signals |
4.3 REGISTERS
This section provides information on the Model 2190
4.3.1 COMMANDS TO CHANGE OR READ REGISTERS
Listed below are the Model 2190 command guidelines to change or read registers. This list provides the command codes and describes the functions of the codes.
ATSn=???Changes the value of a register. "n" = number of register
???= new value of register in decimal
18
