Patton electronic 3087 2.0 Configure the IP address, Power-up indication, Connect a PC and log in

3.Insert the male plug of the AC power cord into an AC power outlet (mains) (100-240 V AC).

1.3 Power-up indication

The Power LED blinks as the ipRocketLink is powering up. When the Power LED stops blinking and remains lit, the ipRocketLink is ready for you to configure.

2.0 Configure the IP address

The ipRocketLink is shipped with a factory-configured IP address to the Ethernet LAN port (green outline). The IP address is 192.168.200.10/24. In most cases, you must change the address to be on the same subnet as your PC, as described in the procedures below. If you are not sure which IP address to use for your installa- tion, contact your network administrator.

2.1 Connect a PC and log in

1.Using the included combination RS-232/Ethernet cable and DB9-RJ45 adaptor, connect a PC’s serial port to the ipRocketLink’s Console port (see figure 1).

Power

Link

WAN

TD	RD
Sync

			100M	Rx
		Link	Tx
	DTR
CTS		Ethernet
Serial

		ipRocketLinkDevice
	3086	Access
ModelIntegrated		Console
SHDSL
G.	- Normal
Modes
	- 511E
Test	- 511

			-
			Local -
			-
		TM	Normal
	ER		Remote
NS
Status

Connect to Console port

PC with

terminal emulator

Serial port

Figure 1. Connecting the ipRocketLink console port to the PC’s RS-232 serial port

2.Start a HyperTerminal (or similar terminal emulation program) session on the PC using the following set- tings:

9600 bps, 8 data bits, 1 stop bit, no parity, no flow control

3.Log into the ipRocketLink using the factory-default login username and password:

Login: superuser

Password: superuser

Login successful

2.2 Modify the IP address

1.Display current IP interface settings for the ipRocketLink Ethernet LAN port.

Model 3087 Quick Start Guide 3