Setting the Print Position
This function adjusts where data prints vertically on the supply. Adjust the print if it is too close to the top or bottom of the supply, or overtypes the
♦If the data is too close to the bottom, increase the number.
♦If the data is too close to the top, decrease the number.
1. From the Config Menu, press ← or → until you see
12.Set Print Position
2. Press Enter. You see
Enter print pos
3. Press ← or → to change the contrast in increments of 1 dot. Press ↑ or ↓ to change the contrast in increments of 10 dots. Pressing ← or ↓ decreases the value (moves the image down);
→or ↑ increases it (moves the image up).
4. When you are finished, press Enter. You return to the Config Menu.