Setting the Supply Position

This function adjusts the printer to print at the vertical 0,0 point on the supply.

Note: The supply position adjustment should only be made on initial printer setup. For format adjustments, change the print position.

You may need to adjust the supply in or out to allow supplies to be removed. The adjustments are in dots (0.0049 inch). The range is –300 to +300 and the default is 0.

1. From the Config Menu, press ← or → until you see

13.Set Supply Position

5. Press Enter. You see

Enter supply pos [-300/300] +0

6. Press ← or → to change the contrast in increments of 1 dot. Press ↑ or ↓ to change the contrast in increments of 10 dots. Pressing ← or ↓ decreases the value (feeds less supply); ← or ↑ increases it (feeds more supply).

7. When you are finished, press Enter. You return to the Config Menu.

R e s e t t i n g t h e C o n f i g u r a t i o n

To change all configurations back to the default settings:

1. From the Main Menu, press . You see

Reset Defaults – Are you sure? Y/N

2. Press Y. The application returns to the default settings. This may take a few minutes.

When it is finished resetting, you return to the Main Menu.

Setting Up the Printer 2-9