Peavey SPECIFICATIONS DU TRANSTUBE 258 EFX, POWER AMP SECTION Rated Power and Load

SPECIFICATIONS DU TRANSTUBE® 258 EFX

POWER AMP SECTION:

Rated Power and Load:

25 W RMS into 8 Ohms

Power @ Clipping (Typically): (5% THD, 1 kHz, 120 V AC line)

20 W RMS into 8 Ohms

Total Harmonic Distortion: Less than 0.5%m 100 mW to 10 W RMS, 60 Hz to 10 kHz, 8 W (typically below 0.2%)

Power Consumption:

50 W, 50/60 Hz, 120 V AC

PREAMP SECTION:

The following specs are measured

@2 kHz with the controls preset as follows:

Channel Select Normal (Out) Low and High @ 10

Mid @ 0

Pre Gain and Post Gain @ 10 Reverb @ 0

Nominal Levels are with Nominal Gain @ 5

Minimum Levels are with Minimum Gain @ 10

All effects “OFF”

Preamp Input (Normal

Channel):

Impedance: High Z, 1 M Ohm

Nominal Input Level: -6 dBV,

70 mV RMS

Maximum Input Level: 0 dBV,

1 V RMS

CD/TAPE INPUT:

Input Impedance: 100 k Ohms Nominal Input Level:

.5 V RMS, -6 dBV (Stereo jack designed for use with stereo headphone outputs on CD/tape players)

Headphone Output:

Load Impedance: 8 Ohms or greater

Nominal Power Output: 20 mW into 8 Ohms (Stereo jacks, monaural signal disconnects internal speaker when phone plug is inserted.)

System Hum and Noise @ Nominal Input Level:

(20 Hz to 20 kHz unweighted)

62 dB below rated power

Equalization:

Special low, mid, and high passive type EQ

Les spécifications sont sujettes à modification sans avis préalable.

18