Peavey TRANSTUBE 258 EFX ESPECIFICACIONES, Power Amp Section, Rated Power and Load, Channel

TRANSTUBE® 258 EFX ESPECIFICACIONES

POWER AMP SECTION:	Nominal Levels are with	20 mW into 8 Ohms
	Nominal Gain @ 5	(Stereo jacks, monaural
Rated Power and Load:	Minimum Levels are with	signal disconnects internal
25 W RMS into 8 Ohms	Minimum Gain @ 10	speaker when phone plug is
	All effects “OFF”	inserted.)
Power @ Clipping (Typically):
(5% THD, 1 kHz, 120 V AC	Preamp Input (Normal	System Hum and Noise @
line)	Channel):	Nominal Input Level:
25 W RMS into 8 Ohms	Impedance: High Z, 1 M Ohm	(20 Hz to 20 kHz unweighted)
	Nominal Input Level: -6 dBV,	62 dB below rated power
Total Harmonic Distortion:	70 mV RMS
Less than 0.5%m 100 mW to	Maximum Input Level: 0 dBV,	Equalization:
10 W RMS, 60 Hz to 10 kHz,	1 V RMS	Special low, mid, and high
8 W (typically below 0.2%)		passive type EQ
	CD/TAPE INPUT:

Power Consumption:

50 W, 50/60 Hz, 120 V AC

PREAMP SECTION:

The following specs are measured

@2 kHz with the controls preset as follows:

Input Impedance: 100 k Ohms Nominal Input Level:

.5 V RMS, -6 dBV (Stereo jack designed for use with stereo headphone outputs on CD/tape players)

Channel Select Normal (Out)	Headphone Output:
Low and High @ 10
	Load Impedance:
Mid @ 0
	8 Ohms or greater
Pre Gain and Post Gain @ 10
	Nominal Power Output:
Reverb @ 0

Specifications are subject to change without notice.

26