(14)EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to indicate the selected effect. Rotating this control clockwise changes the parameter of the active effect according to the descriptions below. The surrounding LED ring indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS |
|
Tremolo - Rate increase | Funk Wah - Sensitivity increase |
Octaver - Wet/Dry mix | Rotary Speaker - Rate increase |
Flanger - Rate increase | Phaser - Rate increase |
Chorus - Rate increase/depth decrease |
|
EFX amps are built with factory settings loaded into the presets. To return to the factory settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on.
(15)REVERB
This control adjusts the overall reverb level. The surrounding LED ring indicates level.
(16)DELAY
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1 repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the control indicate which type is active and volume level. Pressing the control twice sets the delay time to interval between presses.
FOOTSWITCH (NOT INCLUDED)
EFX | CHANNEL | MODULATION | DELAY |
SELECT |
|
| REVERB |
|
|
|
|
|
|
| PFCTM3 | 2 |
|
| 3 |
|
| ||
|
|
|
|
| 1 |
|
|
|
| ||||||
MODE |
|
| PRESET |
| TO STORE PRESET |
|
| PRESET |
|
| PRESET | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | ||||||||
MODE SELECT
The PFC 3 footswitch operates in two modes: EFX Select mode and Preset Select mode. Pressing the MODE SWITCH (17) selects between the two modes. The active mode is indicated by the MODE LED (18). Illumination of the LED indicates EFX Select Mode; a dark LED indicates Preset Select Mode. Controls and indicators
EFX SELECT MODE
NOTE: When entering this mode, the current preset will remain active.
In this mode, PRESET 1 (19) selects between the Lead and Clean channels. The CHANNEL LED (20) will illuminate when the Lead channel is active. PRESET 2 (22) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (21) as a status indicator, the “off” (or lower setting) should be made with the LED dark, and the “on” (or higher setting)
7
