Rear Panel
|
|
|
| OF FIRE HAZARD, REPLACE WITH SAME TYPE 250 VOLT FUSE. | SPEAKER OUTPUTS | CAUTION |
| |
|
| GND. |
| DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE | 120W RMS/44V RMS 4 MIN. |
|
| |
|
|
|
|
|
|
| ||
FUSE |
|
|
| REMPLACER PAR UNFUSIBLE DE MEME TYPE ET DE 250 VOLTS. | SPEAKER JACKS PARALLELED |
|
| |
|
| EFFECTS | PREAMP |
|
|
|
| |
|
| 0 |
| 4 | 8 16 |
| ||
E UF |
|
|
|
| R | |||
S |
|
|
|
|
|
|
| |
FUSE | 120V |
|
|
|
|
|
| A PRODUCT OF PEAVEY |
5A | 60 Hz |
|
|
|
| BUILT UNDER U.S. PATENT NO. 5,197,102 |
| ELECTRONICS CORP. |
400 WATTS |
| SEND RETURN | OUT | SWITCH |
| MERIDIAN, MS MADE IN U.S.A. | ||
|
|
| ||||||
23 | 24 | 25 |
CAUTION
REFER ALL SERVICING TO PEAVEY AUTHORIZED SERVICE CENTER
ALL TUBES 12AX7A
Remote Footswitch Jack (23)
Provided for the connection of the supplied remote footswitch. When the footswitch is plugged into the remote footswitch jack, the Channel Select switch [3] must be pressed to the “in” position for remote selection to operate. Remote selection of the LEAD or RHYTHM channel (left footswitch button) or outboard devices in the effects loop (right footswitch button) is possible with the remote footswitch.
Speaker Outputs (24)
Paralleled 1/4" output jacks for connecting speaker enclosure(s) to the amplifier (minimum: 4 ohms). When using more than one enclosure, be sure to calculate the total impedance and set the Impedance Switch [25] accordingly. (See section on IMPEDANCE SWITCH).
IMPORTANT: Use only high quality, UNshielded cable for speaker connections.
Impedance Selector Switch (25)
Use to select the appropriate impedance of the speaker enclosure(s). If two enclosures of equal impedance are used, the switch should be set at one half of that value (e.g., for two 16 ohm enclosures, set switch to 8 ohms; for two 8 ohm enclosures, set switch to 4 ohms).
Speaker Connection
When connecting the amplifier to the speaker enclosure, make sure to set the impedance selector switch on the rear of the unit to the impedance that matches your enclosure. When two enclosures of equal impedance are used, set the switch to one half the impedance of one enclosure (see [25] Impedance Selector Switch). The 6505 is designed to operate into a minimum of 4 ohms.
11
