POWER AMPLIFICATION SECTION
RATED POWER AND LOAD:
120 W RMS into 16, 8, or 4 ohms
POWER @ CLIPPING:
(Typically @ 5% THD, 1 kHz, 120 V AC line)
130 W RMS into 16, 8, or 4 ohms (Bias must be reduced to measure.)
FREQUENCY RESPONSE:
+0,
HUM AND NOISE:
Greater than 75 dB below rated power
POWER AMP EQ:
Active Presence: +10 dB @ 2 kHz
Active Resonance: +10 dB @ cabinet resonant frequency
POWER CONSUMPTION (Domestic):
400 watts 50/60 Hz, 120 V AC (Domestic)
TUBE COMPLEMENT:
5150® II
SPECIFICATIONS PREAMP SECTION
The following specs are measured @
1 kHz with the controls preset as follows: Low and High EQ @ 10
Mid EQ @ 0 Bright out
Lead and Rhythm Posts @ 10
Presence and Resonance @ 0 dB Nominal levels with Pre Gains @ 5 Minimum levels with Pre Gains @ 10
PREAMP INPUT:
Impedance: Very high Z, 470K ohms
Lead Channel (with channel select in): Nominal Input Level:
1 mV RMS
Minimum Input Level:
.15 mV RMS
Clean Channel (with channel select out): Nominal Input Level:
30 mV RMS
Minimum Input Level:
20 mV RMS
Maximum Input Level: 0 dBV,
1.0 V RMS
(Subtract 24 dB with Crunch switch in.)
EFFECTS RETURN:
Impedance: Very High Z, 470 k ohms
Designed Level:
PREAMP OUT:
Load Impedance: 47 k ohms or greater
Nominal Output: +10 dBV, 3 V RMS
REMOTE FOOTSWITCH:
Special
Channel select and reverb
SYSTEM HUM AND NOISE @ NOMINAL LEVEL (clean channel):
(20 Hz to 20 kHz unweighted) Greater than 63 dB below rated power
EQUALIZATION:
Custom Low, Mid, and High passive type EQ
Push Bright (Rhythm Channel only) +6 dB @ 2 kHz
Push Crunch (Rhythm Channel only) Increases gain
DIMENSIONS (H x W x D):
10" x 26.625" x 11.75"
(25.4 cm x 67.6 cm x 29.8 cm
(1 for clean/crunch, 3 for Lead, 1 for EFX and 1 phase splitter
EFFECTS SEND: | WEIGHT: |
Load Impedance: 47 k ohms or greater | 48.3 lbs. (21.91 kg) |
Nominal Output: |
|
Features and specifications subject to change without notice.
19
