Enclosure Peavey Impulse 100P domestic

Peavey Impulse® 100P

SPECIFICATIONS

Enclosure:

Peavey Impulse 100P (domestic)

Frequency response: 80 Hz to 20kHz

Low frequency limit (-3 dB point): 80 Hz

Useable low frequency limit (-10 dB point): 63 Hz

Internal power amplifiers (@ 120 VAC line): Woofer - 200 Watts peak dynamic power 150 Watts @ less than 0.1% distortion Tweeter - 70 Watts peak dynamic power 50 Watts @ less than 0.1% distortion

Nominal Sensitivity (1 W @ 1 M, swept sine input in anechoic environment):

96 dB

Maximum sound pressure level: 120 dB music peak

Nominal radiation angles:

90˚ horizontal by 45˚ vertical

Transducer Complement:

10" premium heavy-duty, long-throw weather-resistant woofer, and 14XT™ 1.4" titanium diaphragm compression driver tweeter

Box tuning frequency (Fbox): 76 Hz

Electroacoustic crossover frequency: 2000 Hz

Crossover type:

Internal electronic two-way crossover with CD horn EQ, level matching, bass boost and subsonic filtering.

Crossover Slopes:

18 dB/octave (3rd order) low pass, 18 dB/octave (3nd order) high pass, both with staggered poles and driver EQ. Unit has horn spatially aligned with woofer, so there is no need for phase alignment or time delay of the signals.

Electronic input impedance (nominal): 10 k Ohms unbalanced, 20 k Ohms balanced

Input connections:

One combo female XLR/ 1/4" phone jack and one male XLR all providing balanced operation, in parallel. Also has a ??" phone jack based loop-thru that allows other Impulse 100P units to be linked to a single unit for signal source and volume control.

Enclosure materials and finish: Injection-molded high-impact polypropylene of a nominal thickness of 1/4" with internal ribbing and bracing, and with textured finish. Molded material is black.

Mounting:

Subwoofer stand mounting via molded-in mount, flying via Versamount™ 35 (top or bottom of cabinet) and four rubber feet for floor use.

Dimensions:

18.88in. (47.9 cm) tall (17.63 in./ 44.8 cm in rear) by x 14.00 in. (35.6 cm) wide (8.25in./ 21.0 cm in rear) by x 13.13 in. (33.3 cm ) deep

Optional accessories:

Impulse 100 floor monitor kit

Net weight: 35 lbs.

Shipping weight:

Additional Remarks:

Also available as a passively crossed-over unit.

ELECTRONICS AND AMPLIFIER

SPECIFICATIONS:

Electronic input impedance (nominal): Primary balanced input: 10 k Ohms unbalanced and 20 k Ohms balanced

Loop thru input:

High-Z

Infrasonic filter protection: 36 dB/octave roll-off

Nominal amplifier frequency response: +0, -1 dB from 10 Hz to 30 kHz

Hum and Noise:

Greater than 90 dB below rated power

DDT™ dynamic range:

Greater than 14 dB

THD and IM:

Typically less than 0.1 %

Damping factor:

Greater than 100 @ 1000 Hz, 8 Ohms

Power requirements of Impulse 100P System (domestic):

Peavey Enclosure Peavey Impulse 100P domestic, Electronics and Amplifier Specifications

Models: Impulse 100P