POWER
This section describes the proper application of AC power to your MP 400. To insure the safety of you and your MP 400, please pay close attention to any designated cautions.
REAR PANEL
1
4 |
1.IEC POWER SOCKET:
With the Power Switch (#2) in the off (O) position, plug the power cord into this connector
prior to plugging it into your AC power source. Always insure that proper grounding practices are utilized. Damage to the equipment may occur if improper line voltage is used (see voltage marking on unit). Never remove or cut the ground pin of the line cord plug.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black.
(3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or color red.
2.POWER SWITCH (See front panel diagram next page) Place this switch in the “ON” position to turn the unit on.
3.POWER LED (See front panel diagram next page) Illuminates when AC power is being supplied to the mixer.
SPEAKER CONNECTIONS
This section will help you locate the two speaker output jacks on the rear of your MP 400.
WARNING: NEVER ALLOW YOUR TOTAL SPEAKER IMPEDANCE TO DROP BELOW THE MINIMUM IMPEDANCE OF 4 OHMS.
4.SPEAKER OUTPUTS
Two parallel 1/4" jacks are provided at the output of the power amplifier for ease of speaker connection. Minimum speaker impedance (min. load) is 4 ohms.
4
