Rear Panel

DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE

POWER

 

ON

 

100 - 240V

50/60Hz

27 WATTS

42 43

INPUT

BALANCED

 

 

TRS INSERT

1 - GROUND

T (POS)

SLEEVE

2 - POSITIVE

R(NEG)

 

 

TIP

3 - NEGATIVE

S (GND)

 

 

RING

OUTPUT

UNBALANCED

 

 

TIP = SND

1 - GROUND

T (POS)

 

 

2 - POSITIVE

 

 

 

RING = RET

3 - NEGATIVE

S (GND)

 

 

SLEEVE = GND

peavey.com

 

DIGITAL AUDIO

A PRODUCT OF

PORT

PEAVEY ELECTRONICS CORP.

 

 

 

DESIGNED IN USA MADE IN CHINA

 

 

 

 

 

 

 

COMPUTER

MIN

 

RECORD

 

LEVEL

42Power Switch

Depressing the power switch supplies power to the unit.

Warning: The power switch in this unit breaks only one side of the line. Hazardous energy may be present inside the mixer when the power switch is in the OFF position.

43Removable Power Cord

This receptacle is for the IEC line cord (included) that provides AC power to the unit. Connect the line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line voltage is used (see voltage marking on unit). Never remove or cut the ground pin of the line cord plug. The console is supplied with a properly rated line cord. If lost or damaged, replace this cord with one of the proper rating.

NOTE FOR UK ONLY:

If the colors of the wires in the mains lead of this unit do not correspond with the colored markings iden- tifying terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must be connected to the terminal marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter N, or colored black. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or colored red.

44USB port and USB Record Level Control

The USB port is used to connect the PV™ Series USB mixer to acomputer for recording or playing back digital audio to/from your computer. The USB port sends the mixer’s main/tape stereo out to the computer. The amount of the main mix signal being sent to the USB port can be adjusted using the Record Level control located next to the USB port. The USB port receives digital audio from the computer; it can then be assigned through the “Tape/USB to Mix” switch (27) to the main left/right output. The USB input level is controlled by the computer volume control.

Compatible with Windows® XP, ME & 2000. Also compatible with Mac OS X® 10.0 or later.

INPUT

BALANCED

 

 

 

TRS INSERT

1 - GROUND

 

T (POS)

SLEEVE

2 - POSITIVE

 

R(NEG)

 

 

 

 

 

 

TIP

3 - NEGATIVE

 

S (GND)

 

 

 

 

 

 

RING

OUTPUT

UNBALANCED

 

 

 

TIP = SND

 

 

 

1 - GROUND

 

T (POS)

 

 

 

 

 

 

 

RING = RET

2 - POSITIVE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SLEEVE = GND

3 - NEGATIVE

 

S (GND)

 

 

 

 

 

 

 

 

 

 

 

 

DIGITAL AUDIO

 

 

 

 

 

 

 

 

PORT

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

COMPUTER

 

MIN

 

 

 

RECORD

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

LEVEL

 

 

 

 

 

 

 

 

 

 

 

 

44

13

Page 13
Image 13
Peavey PV 20 manual Power Switch, Removable Power Cord, USB port and USB Record Level Control