Peavey PV 20 Insert, Stereo 1⁄4 Inputs, RCA Inputs, 36 A/B Switch, MON Send, Control Room Outputs

Rear Panel

33Insert

The 1⁄4” TRS connectors allow external signal processors to be inserted into the channel signal path. Tip=Send; Ring=Return; Sleeve=Ground.

34Stereo (1⁄4”) Inputs

These 1⁄4” unbalanced inputs work as a stereo line input using both jacks or as a mono input if the con- nection is made to the left/mono input only. The A/B input selector must be in the “A” position for these jacks to be active.

35RCA Inputs

These RCA inputs work as stereo line inputs. The A/B input selector must be in the “B” position for these jacks to be active.

36A/B Switch

The A/B input selector switch expands the capability of the PV™10, PV™14, and the PV™20 mixers by allowing two stereo sources to be connected to each stereo line input. Instead of repatching, the switch selects which input jacks are active.

37MON Send

The MON Send features a 1⁄4” TRS Z-balanced jack in the master section. This output can be used with the Tip, Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connectors. The MON mix is deter- mined by the amount of signal being sent to the MON bus in each channel and by the Monitor Master control (19).

38EFX Send

The EFX Send features a 1⁄4” TRS Z-balanced jack in the master section. These outputs can be used with Tip‚ Ring, Sleeve (TRS) balanced, or Tip, Sleeve (TS) unbalanced connectors. The EFX mix is determined by the amount of signal being sent to the EFX bus in each channel and by the EFX master control.

39Control Room Outputs

The Control Room outputs feature two 1⁄4” TRS Z-balanced jacks. These outputs can be used with Tip, Ring, Sleeve (TRS) balanced, or Tip, Sleeve (TS) unbalanced connectors. The Control Room output level is adjusted with the Headphone level control (21).

40Left/Right Outputs

The left/right Outputs feature two 1⁄4” TRS Z-balanced jacks and two fully balanced XLR outputs. The 1⁄4” outputs can be used with Tip‚ Ring, Sleeve (TRS) balanced or Tip, Sleeve (TS) unbalanced connec- tors. The output level is set by the Master Level Faders (30). Both outputs can be used simultaneously.

41Headphone Output

The Headphone Output is a 1⁄4” TRS (Tip= Left; Ring = Right; Sleeve = Ground). The signal sent to this output is normally the left/right mix. When the Tape to Control Room switch is engaged, the tape input signal is added to the left/right mix and can be monitored in the headphones.

12