Samson GT100C manual Using the Footswitch Jack and Effects Loop, English

Using the Footswitch Jack and Effects Loop

14. If you’re using a professional external signal processor that has Line-level inputs and outputs, turn your GT Series amp off momentarily and then connect a standard shielded audio cable between the rear panel EFFECTS SEND jack and your effects processor input, and another standard shielded audio cable between the EFFECTS RETURN jack and your effects processor output. (If required, multiple effects processors can be daisy-chained together, output to input). Then turn the GT Series amp back on and play your bass while adjusting the controls of your effects processor(s). For best results, set both the input and output gain of

the connected effects processor(s) to 0 dB (unity gain), so that there is no increase or decrease in level whether the effects are switched in or out.

Be sure to adjust the effects processor's WET/DRY balance so that you hear the original signal plus the effects.

15.The Hartke GT100 has a footswitch jack located on the rear chassis panel. Connect the included Dual-button footswitch here. The first button on the footswitch will control the on and off for the CHANNEL 1 CRUNCH control. The second button allows you to switch between Channel 1 and Channel 2.

ENGLISH