Installing Adapter Brackets
WARNING
•Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel screen.
•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.
•Be careful not to pinch fingers when pushing screen from the bottom.
3 | Hook flat brackets onto wall plate (not included). Then |
slowly swing screen in as shown in figure 3.1. Using 4 |
mmsecurity allen wrench (I) turn clockwise until screw fits firmly against wall plate to prevent screen from being removed. Screen can be adjusted horizontally by
loosening M5 x 25 mm screw (B) on flat brackets. | FLAT BRACKETS |
|
NOTE: To lock the screen down, tighten safety/security screws (B) to wall plate as shown.
To remove screen from mount, loosen safety/security screws, swing screen away from mount, and lift screen off of mount.
SAFETY/
SECURITY
SCREW (L)
fig 3.2
WALL PLATE 
fig 3.1
Adjust tension in tilt brackets by rotating ratchet handle. | |
| NOTE: If obstruction prevents ratchet handle from rotating, |
pull handle out while turning will allow handle to reposition without tightening. Release and turn handle to tighten or loosen.
Ratchet handle must be in the up or down position, or interference will occur while hooking tilt brackets to wall plate. Slowly hook tilt brackets onto wall plate and swing screen down. Using 4 mm security allen wrench (I) turn clockwise until screw fits firmly against wall plate to prevent screen from being removed as shown in figure 3.3.
To remove screen from mount, loosen safety/security screws, swing screen away from mount, and lift screen off of mount.
TILT BRACKETS 
WALL PLATE
SAFETY/
SECURITY
SCREW (L)
fig 3.3
5 of 9 | ISSUED: |
Visit the Peerless Web Site at | For customer care call |
