7 | Depending on the specific size & weight of the plasma, | If it is too difficult to adjust roll of plasma, loosen | |
articulating swing arm may be angled at different | screws shown in figure 7.1 using a phillips screw- | ||
| positions, causing plasma to appear to lean sideways |
| driver. |
| at different articulating positions. |
|
|
| allows plasma to be manually adjusted, so plasma can |
| IMPORTANT! Do not loosen or tighten screws |
| be horizontal at all positions. To adjust, gently rotate |
| more than 1/8 turn. |
| plasma by hand to desired position. |
|
|
ARTICULATING ARM
PLASMA
| FOR PLAV 60 ONLY: |
8 | Position of screen may be adjusted vertically up to |
.79" in each direction by doing the following: |
•To lower screen, turn socket screw shown in figure
8.1clockwise with 10 mm allen wrench (V).
•To raise screen, turn socket screw shown in figure
8.1counterclockwise with 10 mm allen wrench (V).
ROLL |
ADJUSTMENT |
SCREWS |
fig 7.1
SOCKET
SCREW 
fig 8.1
9 of 9 | ISSUED: |
©2006 Peerless Industries, Inc. All rights reserved. Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
