WARNING
• Use an assistant or mechanical lifting equipment to safely lift and position the plasma TV.
6 | Insert two M10 screws (F) into swivel box on arm assembly (C) as shown. Leave approx. 1/4" of exposed |
thread. |
SWIVEL BOX
C 
.25"
F
Hook
Install remaining two M10 screws (F) as shown in figure 6.2. HAND TIGHTEN all four M10 screws to allow for tilt adjustment. Remove tape from carriage bolt (I). For tilt adjustment, push back on the top of plasma to relieve pressure on knob. Adjust tilt to desired position and tighten tilt adjustment knob (H), then securely tighten all four M10 screws (F) using 6 mm allen wrench (U).
CAUTION
•After tilt is adjusted, all fasteners must be tightened. Failure to do so will result in damage to the mount.
SWIVEL BOX
I
G H 
I H
F
F
B
fig 6.1 | fig 6.2 |
8 of 9 | ISSUED: |
