4

Attach two pieces of vinyl trim (E) to wall plate (A). Next, attach one piece of vinyl trim to bottom of swivel box on arm

assembly (C).

4-1

Insert one finishing cap (L) into each unused hole of wall plate (A).

L

A

 

SWIVEL BOX

C

E

Note: Refer to adapter bracket instruction sheet for attachment of adapter bracket to plasma before proceeding with step 5. If your adapter bracket has an aluminum race attached to it, remove before proceeding and discard race. It is not used with this product.

5

Insert and tape carriage bolt (I) into top hole of pitch-roll assembly (B). Attach tilt-roll assembly to adapter

bracket with four M10 socket screws (F). Tighten screws using 6 mm allen wrench (U).

Note: Adapter bracket (not UL evaluated, sold separately) will vary in size and style.

CAUTION

Do not overtighten screws! Overtightening may hinder roll option.

B

GENERIC ADAPTER BRACKET

I

F

7 of 9

ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06

Page 7
Image 7
Peerless Industries PLA 60-S, PLAV 60-S manual Assembly C