Pelco 100 Series REINSTALL THE LOWER DOME AND TRIM RING

C2460M-A (7/03) 13

Figure 8. Window Adjustment

REINSTALL THE LOWER DOME AND TRIM RING

1. Domes with Liners (only) – Position the viewing window over the lens of the camera.

a. Loosen the three Phillip screws located in the dome.

b. Insert the blade of a standard screwdriver in one of the adjustment grooves. Move dome

into position.

c. Tighten the three Phillip screws to lock liner in place.

2. Align the screw holes in the trim ring with those in the Camclosure base.

3. Tighten the tamper-resistant screws with the supplied 1/8-inch hollow screwdriver bit.

LOOSEN SCREWS

ADJUSTMENT

GROOVE

DOME LINER

Contents

Main LIST OF ILLUSTRATIONS Figure Page CONTENTS Section Page CAUTION IMPORTANT SAFEGUARDS AND WARNINGS REGULATORY NOTICES WELCOME INSTALL THE BACK BOX REMOVE THE LOWER DOME INSTALL THE BACK BOX Attach Directly to a Wall/Ceiling IMPORTANT Attach Directly to Concrete Wall/Ceiling Attach to a 4S Electrical Box Mount to a Plaster Ring CONNECT POWER WIRES INSTALL THE CAMERA MODULE CHECK HEATER JUMPER INSTALL AND POSITION THE CAMERA ZOOM/FOCUS DIGITAL SLOW SHUTTER (DSS) MAKE CAMERA SETTINGS AGC (AUTOMATIC GAIN CONTROL) BLC (BACK LIGHT COMPENSATION) VERTICAL PHASE ADJUSTMENT (24 VAC OPERATION ONLY) How to Adjust the Phase Control VARIFOCAL LENS AUTO IRIS LEVEL ADJUSTMENT REINSTALL THE LOWER DOME AND TRIM RING SPECIFICATIONS C2460M-A (7/03) 15 REVISION HISTORY Manual # Date Comments C2460M 4/03 Preliminary manual for beta testing. C2460M-A 7/03 Final version. WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico: