Pelco 100 Series Mount to a Plaster Ring

C2460M-A (7/03) 7

Mount to a Plaster Ring

Refer to Figure 4 for the following steps. Installation instructions assume that the 4S electrical box

and plaster ring were previously installed.

1. Pull video and power wires into the base.

2. Attach the base to the plaster ring.

- Use the two 8-32 x .750-inch pan head screws to attach the base to a 401 plaster ring.

- Use the three 6-32 x .750-inch pan head screws to attach the base to a 404 plaster ring.

3. Connect the video cable.

Figure 4. Mounting to a Plaster Ring

SCREW (SUPPLIED);

SEE TEXT FOR SIZE

WALL OR

CEILING

401 OR 404

PLASTER RING

BASE

4S ELECTRICAL

BOX

Contents

Main LIST OF ILLUSTRATIONS Figure Page CONTENTS Section Page CAUTION IMPORTANT SAFEGUARDS AND WARNINGS REGULATORY NOTICES WELCOME INSTALL THE BACK BOX REMOVE THE LOWER DOME INSTALL THE BACK BOX Attach Directly to a Wall/Ceiling IMPORTANT Attach Directly to Concrete Wall/Ceiling Attach to a 4S Electrical Box Mount to a Plaster Ring CONNECT POWER WIRES INSTALL THE CAMERA MODULE CHECK HEATER JUMPER INSTALL AND POSITION THE CAMERA ZOOM/FOCUS DIGITAL SLOW SHUTTER (DSS) MAKE CAMERA SETTINGS AGC (AUTOMATIC GAIN CONTROL) BLC (BACK LIGHT COMPENSATION) VERTICAL PHASE ADJUSTMENT (24 VAC OPERATION ONLY) How to Adjust the Phase Control VARIFOCAL LENS AUTO IRIS LEVEL ADJUSTMENT REINSTALL THE LOWER DOME AND TRIM RING SPECIFICATIONS C2460M-A (7/03) 15 REVISION HISTORY Manual # Date Comments C2460M 4/03 Preliminary manual for beta testing. C2460M-A 7/03 Final version. WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico: