Pelco 100 Series IMPORTANT

C2460M-A (7/03) 5

Loosen the tamper-resistant screws with the supplied 1/8-inch hollow screwdriver bit. Remove the

lower dome and place it to the side.

The installation methods for the ICS100 back box

include the following:

•Attach Directly to a Wall/Ceiling

•Attach Directly to a Concrete Wall or Ceiling

•Attach to a 4S Electrical Box

•Mount to a Plaster Ring

Select the best method for your installation, and

then refer to the following pages for instructions.

Refer to Figure 1 for the following steps.

1. Cut a small hole in the ceiling or wall and pull video and power wires into the base.

2. Attach the back box to the wall/ceiling (hardware not supplied).

3. Connect the video cable.

CONDUIT

PLUG

SET SCREW

IMPORTANT

To maximize tamper

resistance

when not

using the

side conduit

opening for

wire connections,

verify that the conduit

plug and set screw are tight.

MOUNTING

HARDWARE

(NOT SUPPLIED)

WALL OR

CEILING

BASE

Figure 1. Installation Directly to a Wall/Ceiling