Pelco 100 Series INSTALL THE CAMERA MODULE

C2460M-A (7/03) 9

INSTALL THE CAMERA MODULE

CHECK HEATER JUMPER

The Camclosure is equipped with a heater to defrost the dome. Some installations may not require

this heater. If the unit will never be subjected to a frost temperature, you can disable the heater,

saving power requirements. To disable the heater, remove the jumper cover from the J1 jumper

block (refer to Figure 6). It is recommended that the jumper cover be left in the unit by installing it

on one of the jumper pins.

Figure 6. Heater Jumper and Camera Connector Locations

J1 JUMPER

CAMERA CONNECTOR

Contents

Main LIST OF ILLUSTRATIONS Figure Page CONTENTS Section Page CAUTION IMPORTANT SAFEGUARDS AND WARNINGS REGULATORY NOTICES WELCOME INSTALL THE BACK BOX REMOVE THE LOWER DOME INSTALL THE BACK BOX Attach Directly to a Wall/Ceiling IMPORTANT Attach Directly to Concrete Wall/Ceiling Attach to a 4S Electrical Box Mount to a Plaster Ring CONNECT POWER WIRES INSTALL THE CAMERA MODULE CHECK HEATER JUMPER INSTALL AND POSITION THE CAMERA ZOOM/FOCUS DIGITAL SLOW SHUTTER (DSS) MAKE CAMERA SETTINGS AGC (AUTOMATIC GAIN CONTROL) BLC (BACK LIGHT COMPENSATION) VERTICAL PHASE ADJUSTMENT (24 VAC OPERATION ONLY) How to Adjust the Phase Control VARIFOCAL LENS AUTO IRIS LEVEL ADJUSTMENT REINSTALL THE LOWER DOME AND TRIM RING SPECIFICATIONS C2460M-A (7/03) 15 REVISION HISTORY Manual # Date Comments C2460M 4/03 Preliminary manual for beta testing. C2460M-A 7/03 Final version. WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico: