8C2460M-A (7/03)
Figure 5. Terminal Block for Input Power
CONNECT POWER WIRES
Depending on the input voltage, connect either the 12 VDC or 24 VAC input power wires to the
terminal block inside the base. Refer to Figure 5 for the location of the terminal block.
DC Operation – Refer to the enlarged portion of Figure 5 for the 12 VDC (+) and ground (-)
connections.
AC Operation – It does not matter which terminals the power wires are connected to. However, if
you are wiring more than one Camclosure system to the same transformer, connect one side of the
transformer to the same terminal on all units, and connect the other side of the transformer to the
remaining terminal. Failure to connect all of the units the same way will cause the cameras to be
out of phase with each other and may produce a vertical roll when switching between cameras.