Pelco C1043M-A - page 13

Pelco Manual C1043M-A (2/96) 9

Figure 7. Inter-Check’ s Two Text Screens

SCREEN # 1

TEXT WI NDOW

SCREEN #

TEXT WI NDOW

PELCO

4.0 PROGRAMMING

To enter the SELECT MENU press enter . The follo wing

menu will be displayed on monitor:

SELECT MENU

1. Register # 1 or 2

2. Operator # 1 or 2

3. Exceptions on/off

4. Camera select

5. Screen print on/off

6. Auto camera search on/off

7. Reverse video on/off

8. System program

9. Exceptions program

0. Syssave/Sysread

4.1 REGISTER 1 OR 2 SELECT

This menu allows you to manually display the transaction

data from a specific register on either Screen 1 (the left-

hand side of the monitor) or Screen 2 (the right-hand side

of the monitor). (See Figure 7.) T o enter this menu, press

[1]. The monitor will display: Screen 1 or 2?

Select the screen (1 or 2) on which you want your register

data to be displayed and then press [Enter].

The next prompt is: Enter Register #_

Type in the Register number to be monitored. Press

[Enter]. Pressing [Enter] without selecting a Register

will turn off the previously selected screen. For ICI3000P

installations, register numbers correspond to the address

of the ICI1000PIM installed within the register.

4.1.1 Register Selection Using the

Hot Key F1

To select a specific Register for monitoring while in the

monitoring mode:

1. Press [F1]

2. Select appropriate Screen # (no prompt is displayed):

Pressing [1] = Screen 1, Pressing [2] = Screen 2

3. Select Register # or PIM NUMBER for monitoring.

4. Press [ENTER].

4.2 OPERATOR # 1 OR 2

This menu allows you to manually display the transaction

data from a specific operator on either Screen 1 (the left-

hand side of the monitor) or Screen 2 (the right-hand side

of the monitor). T o enter this menu, press [2]. The monitor

will display: Screen 1 or 2?

Select the screen (1 or 2) on which you want your register

data to be displayed.

The next prompt is: Enter operator # OPR ??

Type in the operator number to be monitored (up to three

digits). Press [Enter]. Pressing [Enter] without

selecting an Operator will turn off the previously selected

screen.