MATING CONNECTOR ASSEMBLY
To assemble the
1.Discard the white plastic sleeve that is included with the connector assembly. Thread the cable through the compression nut/strain relief and connector shell.
CONNECTOR
SHELL
COMPRESSION NUT
AND STRAIN RELIEF
4.Solder the individual conductors to the appropriate pins in the back of the connector (refer to Figure 2). Push the rubber grommet into the back of the connector.
BACK OF CONNECTOR
GROMMET
2. Prepare the cabling by doing the following:
Control Cable
a.Strip the outer jacket back 2 inches (5 cm).
b.Strip the individual conductors back
RUBBER
GROMMET
3. Assemble the back of the connector.
6
5.Screw the connector shell to the back of the connector and tighten. Tighten the compression nut/strain relief as far as possible to compress the sealing ring inside the shell. Attach the cable clamps to the compression nut/ strain relief.
THREADED END
COMPRESSION NUT AND STRAIN RELIEF
CONNECTOR SHELL
CABLE CLAMP
THREADED END