Installation
MOUNTING
To attach the enclosure to the pan and tilt unit, perform the following installation steps.
1.Make sure the tilt shaft on the pan and tilt unit is near horizontal so that the connector in the tilt shaft is pointing upward.
2.Lift the housing over the pan and tilt unit, and align the connector in the bottom of the enclosure to the mating connector in the top of the pan and tilt unit.
3.Place the enclosure down onto the pan and tilt unit. Move the enclosure
4.Balance the enclosure on the pan and tilt. Tighten the two screws in the back of the RediLINK clamp with a
CAMERA AND LENS INSTALLATION
To install the camera and lens, perform the following steps:
1.Remove the rear plate of the enclosure. Refer to Figure 1 and do the following:
a.Remove the spiral retaining ring from the back of the enclosure. Use a screwdriver to pry the end of the spiral retaining ring from the retaining ring groove.
b.Pull on the
2.Slide the sled out of the enclosure.
3.Remove the desiccant bag from the camera sled. Do not discard the bag.
4.Mount the camera and lens onto the sled:
a.Extend the lens to the maximum length before positioning the camera and lens.
b.Position the camera and lens so that they do not extend beyond the track.
c.Fasten the camera and lens to the sled. Fastener is not supplied.
5.Connect wiring for camera power, lens functions, and video. Refer to Figure 2.
6.Unwrap and install the desiccant bag inside the enclosure.
7.Reinstall the camera sled by sliding it back into the enclosure body. Secure with the spiral retaining ring.
8.Pressurize the inside of the enclosure and assemble the mating connector. Refer to the sections Recharging the Enclosure and Mating Connector Assembly.
4 |
