Pelco C1669M (4/05) , IMPORT PHASE

4 C1669M (4/05)

To export the DX8000 DVR settings:

1. Insert a USB key into one of the DX8000 USB ports on the front panel.

2. Click Edit > Export Setup.

3. Double-click the drive assigned to your USB key.

4. Type a name for your backup ﬁle in the File name text box, and then click Save. The DX8000 exports the settings to the USB key.

5. Do the following:

a. Click File > Exit. The Shut down dialog box opens.

b. Select Exit to Windows Mode from the drop-down menu. The Log On to Windows dialog box opens.

c. (Optional) Enter the Windows password (not required for V1.0).

d. Click OK. The system logs you into the Windows operating system.

6. When the DX8000 is in the Windows environment, do the following:

a. To stop the USB device, on the Windows taskbar, left-click the Unplug or Eject Hardware icon. The Stop USB Mass Storage Device

message dialog appears next to the icon.

b. Click Stop USB Mass Storage Device. The Safe to Remove Hardware dialog box opens.

c. Click OK.

d. Unplug the USB key.

This procedure describes how to record the DX8000 IP security settings.

NOTE

Remain in the Windows environment to perform the following procedure.

To record the DX8000 IP security settings:

1. Click the Start button.

2. Click Programs > Manage IPSec Policy.

3. Record the status of Enable IP Security Policy.

Enable IP Security Policy: Checked_____ Unchecked_____

4. Click cancel to exit.

IMPORTANT:

•

You must complete steps 1, 2, and 3 before running the recovery procedure.

•

Please complete the

DX8000 Recovery Procedure

on page 6 before performing the Import Phase.

IMPORT PHASE

This section describes how to import the network settings that you previously backed up and is organized as follows:

• Step 5: Entering Networking Settings

• Step 6: Importing the DX8000 DVR Settings

• Step 7: Conﬁguring IP Security Settings