20 Pelco Manual C1927M (5/99)

4. When the menu item you desire is highlighted (blinking), do one of the following:
• If a menu item has more than one option, press the +/- button to cycle through
the options to select the one you want.
• If a menu item has only one option, press the +/- button to select it.
Time and Date
Set the current time and date. The time uses a 24-hour clock.
Time Display
ON - Displays the time on the main monitor.
OFF - The time is not shown on the main monitor.
Title Display
ON - Displays camera titles on the main monitor.
OFF - Camera titles are not shown on the main monitor.
Record Speeds
Sets the speed at which the VCR normally records video and the speed at which it
records when there is an alarm(s). Setting the speeds in the System Setup menu also
sets the speeds in the Record Setup and Custom VCR Setup menus.
Main Monitor Display
The options are High Resolution or Reduced Flicker. Reduced Flicker can be selected
when there is flickering on the monitor screen, such as from a neon light. This is more
visible to the eye in PAL format multiplexers.
Global Setups
Video Terminations
These settings set the terminations for all video inputs. To set individual inputs, refer
to the
Camera Setup
section.
Set to 75 OHM when all equipment is connected only to the video IN connectors.
Set to LOOP HI-Z when all equipment is connected to the video OUT (looping) connec-
tors. Equipment connected to the looping connectors must be terminated at 75 ohms.

Figure 11. Basic System Setup Menu

2/6/8 Hr
2/6/8 Hr
MAIN MONITOR DISPLAY
RESET ACTIVITY DETECTION ALL CH TO
*2,6,or 8 Hr 120 Hr
12 Hr 168 Hr
16 Hr 180 Hr
18 Hr 240 Hr
24 Hr 360 Hr
48 Hr 480 Hr
72 Hr 600 Hr
84 Hr 720 Hr
96 Hr 960 Hr
HIGH RESOLUTION
HIGH RESOLUTION
REDUCED FLICKER
* 2/6/8 HR FOR NTSC/EIA MODEL MULTIPLEXERS, 3 HR FOR PAL/ CCIR MODELS.
REMAINING RECORD SPEEDS DEPEND UPON VCR MODEL.
3
TIP:
In any menu you can
reverse the direction in
which the options cycle by
double-pressing the +/- but-
ton.
TIP:
You can exit a menu
by pressing the correspond-
ing button for approximately
three seconds as you did to
enter the menu.
NOTE:
Title Display shows
a maximum of 12 characters
in all modes except 16-cam-
era display, in which only 9
characters are shown.