C2403M-E (2/08) 7
Installation

MOUNTING DIRECTLY TO SURFACE

WIRING THROUGH BASE

Follow the proceeding steps when feeding wire/cables through the base of the cover and back box:
1. Using the cover as a template, mark one of
the large hole positions onto the mounting
surface.
2. Cut out the hole in the mounting surface for
power and video wiring.
3. Pull video and power wires through the
hole in the cover.
4. Attach the cover to the mounting surface
(hardware not supplied). Use stainless steel
hardware when installing the system
outdoors.
5. Connect the video cable.
6. Connect the power wires.
• For 12 VDC, connect the 24 VAC/12
VDC (red) and GND (black) wires to
input power. The blue wire is not
used.
• For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.
The black wire is not used.
7. Install the back box inside the cover. Rotate and position the back box so that the conduit plug on the
side of the box is located on the opposite side (180 degrees) from the notch on the side of the cover.
Use the supplied 8-32 x 0.375-inch screws and washers to secure the back box to the cover.
NOTE: For vandal-resistant installations, the conduit plug located on the side of the back box should be
hidden if it is not used. To hide the conduit plug rotate the back box so that the plug is located on the
opposite side (180 degrees) from the notch on the side of cover.
COVER
BACK BOX