Pelco C2406M-F ADJUSTMENTS (COLOR CAMERA ONLY)

8C2406M-F (4/04)

ADJUSTMENTS (COLOR CAMERA ONLY)

If you have a color camera, it is set up at the factory and normally requires no adjustments.

Sometimes, however, adjustments may be necessary.

1. Remove the cover using the supplied 1/8-inch hollow screwdriver bit.

2. Adjust the vertical phase, iris level, focus, or switch settings (refer to procedures below).

3. Replace the cover.

Adjustment is required if there is vertical roll when

switching between two cameras.

1. Reverse the 24 VAC connections on one camera. If

both cameras are connected to the same

transformer, this should solve the problem.

2. If reversing the connections does not solve the

problem, or if cameras are connected to different

transformers, turn the adjustment screw on one

camera (while switching as rapidly as possible

between the two camera views) until the

switching is clean and there is no vertical roll. If

more than two cameras are out of synchronization

with each other, choose one camera and

synchronize all others to it.

FIXED LENS

VERTICAL

PHASE

ADJUSTMENT

Figure 11. Vertical Phase Adjustment

VARIFOCAL LENS

VERTICAL PHASE

ADJUSTMENT

If you have a varifocal lens or fixed focal length lens with an auto iris, you can adjust the iris level

setting to increase or decrease brightness.

IRIS LEVEL

ADJUSTMENT

AUTO IRIS LEVEL

ADJUSTMENT

Figure 12. Iris Level Adjustment

FIXED LENSVARIFOCAL LENS