Pelco C2406M-F INSTALL BASE

C2406M-F (4/04) 5

INSTALL BASE

1. Outdoor Installation Only – Bring the power and video wiring for the camera through the

wiring hole in the watertight mounting plate. Then fasten the mounting plate to the mounting

surface with #8 stainless steel screws (not provided) of the appropriate length.

2. Connect power input wires to the wires in the

base of the Camclosure.

24 VAC – Connect power to the red and blue wires.

12 VDC – a. Connect +12 VDC to the red wire and

ground to the black wire.

b. Reset the voltage jumper on the

camera power board. Refer to

Figure 3. Remove the jumper

from JP1 (AC) and reinstall the

jumper on JP2 (DC).

3. Connect the video cable. Make sure the boot covers the BNC connectors.

4. Push the power wires and video cable back through the mounting surface. Line up the

mounting holes in the base with the mounting holes on the mounting surface, and attach the

base as follows:

If you are attaching the base to the watertight mounting plate, use the three 10-32 x 0.625-inch

screws and lock washers that are provided.

If you are fastening the base directly to a wall or ceiling, use appropriate hardware (not

supplied). Use 1/4-20 hex head bolts with wall anchors in high-vandalism installations.

FOUR-PIN

POWER

CONNECTOR

24 VAC

12 VDC

Figure 3. Voltage Jumper Settings

1. Outdoor Installation Only –

Insert the hole plug that is

supplied into the large hole in the

water-tight mounting plate (refer

to Figure 4). Then fasten the

mounting plate to the mounting

surface with #10 stainless steel

screws (not provided) of the

appropriate length.

2. Using a blunt tool push out the wiring plug in the

Figure 4. Install Hole Plug

HOLE PLUG

WATERTIGHT

MOUNTING PLATE